IPB

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
Rear Quarter Panel Damage, Time to learn some body repair skills
acanfield
post Jul 26 2017, 04:59 PM
Post #1


Member
***

Group: Members
Posts: 98
Joined: 21-June 10
From: La Plata, MD
Member No.: 11,411



Well hey all--I think this is my first visit to this sub-forum.

Someone scraped and dented the left rear quarter-panel on our faithful Suburban. Other than some scrapes on the front bumper I was proud that the body was original and the paint is good.

Attached File  Suburban_left_rear_dent_SMALL.jpg ( 117.65K ) Number of downloads: 2


They obviously got into it good since it scraped to the metal then dented the panel. It happened at work, but I haven't been able to track down the culprit.

What do you all think this would run at a body shop? $100? $200? I imagine they have a minimum amount to even make it worth their while.

Since it's isolated to the lower portion of the panel I was thinking I might be able to hammer, sand, bondo, and paint the section myself. Any suggestions or quick pointers?


--------------------
2004 Chevrolet Suburban Z71
2006 Chevrolet Silverado Z71
Go to the top of the page
 
+Quote Post
carguru
post Jul 26 2017, 05:17 PM
Post #2


Needs a Life!
**********

Group: Moderators
Posts: 13,003
Joined: 2-July 04
From: Cary, NC
Member No.: 18



Good body shop will likely run $500-600. That is a lot of manual labor in that creased sheet metal. Try to get a painless dent repair guy to look at it. It may not fully straighten out, but they might be able to do a miracle on the cheap. Even if they don't take out all the creases, you will have a much better starting point with minimal filler.


--------------------
DC
Go to the top of the page
 
+Quote Post
acanfield
post Jul 26 2017, 06:16 PM
Post #3


Member
***

Group: Members
Posts: 98
Joined: 21-June 10
From: La Plata, MD
Member No.: 11,411



QUOTE (carguru @ Jul 26 2017, 05:17 PM) *
Good body shop will likely run $500-600. That is a lot of manual labor in that creased sheet metal. Try to get a painless dent repair guy to look at it. It may not fully straighten out, but they might be able to do a miracle on the cheap. Even if they don't take out all the creases, you will have a much better starting point with minimal filler.


Thanks for the solid feedback. I figured it wasn't as simple as I hoped.

This only reinforces the aggravation factor, but I have to remind myself there is a reason I drive my clean "older" used cars. If this was a new Suburban I'd be really bent.


--------------------
2004 Chevrolet Suburban Z71
2006 Chevrolet Silverado Z71
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic

 



RSS Lo-Fi Version Time is now: 21st August 2017 - 09:45 AM